Stress Analysis of Cold Rolled Steel Sheet Based on ABAQUS

Article Sidebar

PDF
Published: Oct 20, 2019
DOI: https://doi.org/10.26483/ijarcs.v10i5.6469
Keywords:
stress, finite element, friction coefficient, cold rolling

Main Article Content

Jin XING
Binzhou University Binzhou, China E-mail: qizhen_900@126.com

Abstract

Stress is one of the key factors affecting cold rolling effect. In order to determine the influence of process parameters on cold rolling stress of wear-resistant steel, finite element analysis software ABAQUS was used to analyze the rolling process. In the analysis process, the solver adopts explicit dynamic scheme, and the research method is a single variable method. The stress variation characteristics are calculated under different tension and friction coefficient before and after rolling. According to the analysis results, the stress is related to the tension. The stress increases first and then decreases with the rolling direction. The cold rolling stress can be significantly increased when the friction coefficient increases to a certain value.

Downloads

Download data is not yet available.

Article Details

Issue
Vol. 10 No. 5 (2019): September-October 2019
Section
Articles

COPYRIGHT

Submission of a manuscript implies: that the work described has not been published before, that it is not under consideration for publication elsewhere; that if and when the manuscript is accepted for publication, the authors agree to automatic transfer of the copyright to the publisher.

Authors who publish with this journal agree to the following terms:

  • Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
  • Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
  • Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work
  • The journal allows the author(s) to retain publishing rights without restrictions.
  • The journal allows the author(s) to hold the copyright without restrictions.
Author Biography

Jin XING, Binzhou University Binzhou, China E-mail: qizhen_900@126.com

Binzhou University

References

H. Xiuhua. “Microstructure and properties of wear-resistant steel Mn13 hot-rolled sheet,†Metal heat Treatment, vol.32, pp.206-209, October 2015.

L. Liu-min, H. Guiyun. “Effect of cold rolling deformation on the structure and properties of Mn13 wear resistant steel,†Computer Simulation, vol.33, pp. 234-237, August 2016.

L. Hongsheng. “Development of DC03+C590 cold-rolled steel strip for automobile sealing strip,†Computer Simulation, vol. 31, pp. 407-411, January 2014.

L. Qiaohua. “Cause analysis and improvement of hollow shaft damage of cold rolling coiler,†Journal of Automotive Engineering, vol. 01, pp. 464-468, April 2014.

Q. Canwen. “Multi-physical field coupling study of gasoline engine seal performance based on finite element analysis,†Lubrication and Sealing, vol.3, pp. 45-47, June 2018.

Z. Zhiguo, P. Yugang. “Research on explicit dynamic analysis method based on ABAQUS,†Mechanical Design and Manufacturing, vol.24, pp.208-215, July 2015.

W. Kesheng, Z. Leiqiang. “A new exact penalty function method for solving inequality constraints,†Computer Simulation, vol.28, pp.342-347, April 2013.